Orb Pendant: how it works

Step by step.

The same steps, for when you can’t play sound. Swipe through.

  1. 01/09

    Step 1 · Turn it on

    The magnet charm hangs at the back of the chain.

  2. 02/09

    Step 1 · Turn it on

    Tap the charm to the Orb and it lights. Tap again to turn it off.

  3. 03/09

    Step 2 · Change the battery

    Undo the two screws on the back.

  4. 04/09

    Step 2 · Change the battery

    Lift off the back plate and take ORB-1 out.

  5. 05/09

    Step 2 · Change the battery

    Push the old CR927 battery out of the open side.

  6. 06/09

    Step 2 · Change the battery

    Put the new CR927 (3V) in, with the (−) side up.

  7. 07/09

    Step 3 · Put it back

    Line ORB-1’s two bumps up with the Orb’s two notches.

  8. 08/09

    Step 3 · Put it back

    Set ORB-1 back in, so it sits flat.

  9. 09/09

    Step 3 · Put it back

    Back plate on, both screws in. That’s it.

The one to get right

Bumps into the notches.

ORB-1 has two small bumps on its edge. Inside the Orb are two notches. Turn ORB-1 until both bumps drop into the notches, and it sits flat.

If the back plate won’t sit flat, ORB-1 isn’t in its notches yet. Take the plate off, turn ORB-1 until it drops in, and close it again.

Care

Wearing it.

Water

Light rain and splashes are fine. Take it off to shower, swim or bathe, and don’t submerge it.

Knocks and drops

The stone is natural, so a drop or a hard knock can break it. The chain and its magnet charm can be damaged too.

Warranty

Two years for manufacturing defects. Accidental breaks and the chain aren’t covered, though we sometimes offer up to 25% off a replacement. HumanCare, if you add it when you register, covers one accidental replacement within three years, chain and magnet charm included.

Register your Orb →Warranty + HumanCare →

Need help?

Write to us and a real human answers.

Wearing a Spire? How Spire works →